Design and feasibility testing of a high resolution, 3D printer using concentrated solar power

Research output: Contribution to journalArticle

Abstract

Additive manufacturing (3D printing), combined with computer aided design, is transforming the modern manufacturing industry. Using high temperature techniques such as “selective laser sintering”, fabricators are given access to a wide range of starting materials. The sustainability of the approach could be improved through the direct use of concentrated sunlight to sinter these powders. Using inexpensive components, the cost can also be decreased to enable utilization by microbusinesses, especially those operating in remote, off-grid locations. For achieving this goal a high resolution prototype has been developed and constructed using a Fresnel lens design. To determine the feasibility of the method, two dimensional sintering tests were conducted on a commercial Nylon 12 powder. The effects of the most influential parameters on this process were determined through the implementation of a simplified model and dimensional analysis.

The most important parameter for the description of the process was found to be the dimensionless ratio of incoming radiative power to power required for sintering or melting. For conditions in which only a single phase transformation takes place, this parameter was found to remain constant, with a mean of 6.84 and variance of 0.04. The limits of the power to speed ratio were also determined, achieving thicknesses as low as 0.3 mm for the selected powder and lens combination. The measured parameters demonstrate the feasibility of high resolution 3D printing using the proposed technique, provided that tailored control strategies are developed. A major limitation was found to be the focal spot size of the lens, which determines the track width. This can be improved from the current value of 3 mm through the use of a cast glass lens.

Bibliographical metadata

Original languageEnglish
Pages (from-to)13-23
Number of pages10
JournalSolar Energy
Volume185
Early online date17 Apr 2019
DOIs
Publication statusPublished - Jun 2019